Mimaki CG/AR Sheet Setup

Rollers need to be aligned within the horizontal white bars.



Lift rear roller lever to lift the rollers up so you can load the material under the rollers.
When loading a sheet, sheet needs to cover the sensor.



Lower the rear roller lever to lower the rollers onto the loaded material and press the right arrow button. The Mimaki cutter should begin to the carriage and sheet around as it determines the size of the sheet.



Once the material is loaded OK, press the FUNC3 button which will put the cutter into REMOTE mode.



Now that the Mimaki is in REMOTE mode, it can now accept data from Sure Cuts A Lot.



In Sure Cuts A Lot, Connection should be set to USB and the Port should be set to <Auto Detect>



Cookies
This website uses cookies. By using and further navigating this website you accept this. Detailed information about the use of cookies on this website is available by clicking on more information
Close